|
Hanging Instructions
QUICK FEEDERS must be mounted within a safe, dry,
covered area. DO NOT attempt to make modifications or
changes to this product or warranty may be nullified and
voided.
INSTALLATION: Locate your new feeder close to a 110-volt
receptacle for electric power. Mount feeder on a
suitable outer stall wall OUT OF THE ANIMALS REACH for
horses and other grain fed animals.
See Figures A, B or C for mounting applications for
your animal or pet. Note: Wall must be solid and
sturdy.
Determine a mounting height that allows the PVC pipe to be
directed back through the stall wall into the feed
bucket as in Figure A (feed bucket height may need to
be lowered to accommodate ease in refilling the QUICK
FEED hopper).
For domestic pets, install feeder according to Figs A,
B, or C.
For all applications locate top center mounting hole on
back of hopper and mark wall. Install screw, hang
feeder on single screw, level unit and mark remaining 3
mounting holes. Install all 4 screws using washers;
tighten screws firmly.
Figure A
Typical Outer Stall Installation: Slip PVC 45° ell (do
not glue) over the spout adapter. Determine where the
PVC pipe will penetrate the stall wall and mark. Cut
hole through stall wall . Insert PVC through hole and
into PVC 45° ell. Mark and cut off excess PVC pipe to
correct length. CAUTION: Do not leave PVC pipe
protruding inside stall or feed bucket where the animal
can reach it. Cut flush with inside wall.
Figures B & C
Figures B & C - Direct Drop Installation: After
hanging feeder slip coupler over spout
adapter. Determine length for PVC pipe and cut to
size. Slip PVC 45 ell over end if desired, slip pipe
into coupler.
|
